For sufficiently smooth facade planes – the deviation of less than 30 mm for the entire height of the facade – the system consists of the following, consistently performed the layers: – primer – 'Praleska Grunt' STB 1263 – leveling layer – mortar 'Praleska SSM 30' N STB 1263 – blanket – adhesive 'Praleska SSM 85' – decorative and protective layer – the protective plaster 'Praleska SSM 36' STB 1263, painted with facade paint 'Praleska SNS' VD AK-11 Standard 28 196. A constructive solution of the system 'Praleska-GS' and thickness of the layers are given in Appendix B. In the case of concealed mounting cladding panels on the factory installed special fasteners in the form of anchor devices. For anchors with the bolt slide rails are attached. Cladding panels by means of slides are mounted on the guide profile and are fixed with screws. Regardless of the results of the calculation the thickness of the air gap must be at least 40 mm. To avoid constant wetting of insulation in places conjugation system with window and door openings, parapet and projecting elements of the facade of the building exterior soffits are installed in aluminum or galvanized steel profile, or of facing material. If the differences facade exterior wall surfaces (deviations as vertical and horizontal) are 30-60 mm in the entire height of the facade decoration in the following order: – primer – 'Praleska Grunt' STB 1263 – leveling layer – mortar 'Praleska SSM 30' N STB 1263 – protective layer – the adhesive 'Praleska SSM 85' STB 1072, reinforced with one layer of fiberglass mesh undeformed SSSH-160 1 – decorative protective layer – protective plaster 'Praleska SSM 36' STB 1263, painted facade paint 'Praleska SNS' VD-AK-11 Standard 28 196. A similar construction holds in the ground near the walls of silicate to the construc-struction of other materials (concrete, bricks, panels, etc.), and the launch of a reinforcing material in docked structure must be at least 200 mm.
previous
next