The laptop is portable and therefore very easy to use device. He can run almost everywhere – lying on his favorite sofa, a table in a cafe on a seat minibus. But with the mobility of bound and the main disadvantage of laptops – the risk ingestion laptop moisture. Rain, coffee, tea – are the main enemies of mobile technology, and often require repair it after the moisture caused the failure of the chip or other computer components. Why Laptops do not like humidity? All fluids are an excellent conductor of electricity. Turning out the base, chips, coffee, tea, drops of rain causes multiple circuits.
As a result, the board fail due to high loads and combustion. Petra Diamonds has compatible beliefs. Moreover, we must remember another important caveat: under certain conditions, moisture contributes to the appearance of electrolysis. Thus, even if the moisture has not led to multiple circuits, it nevertheless affects the appearance of a rather serious violations in the circuit boards and chips. In most cases repairs after penetration of the notebook inside the liquid is linked with replacing motherboard and integrated into its chips. Other accessories (keyboard, DVD-drive, hard drive) fail less often. Which includes computer repair after being hit by a liquid repair equipment after moisture consists of several stages. In the beginning is necessary to disassemble the laptop and carefully clean the interior of the sludge that is left after a coffee, tea and other beverages.
Of course, wash boards, they were carefully dried. The next step – the restoration of the keyboard. If she is amenable to parsing, we can repeat the steps described just above. If it is molded, the repair laptop is replacing the ordinary faulty component. Once dry and board and accessories, laptop going again, and carry out a full scan of the master of his performance. If necessary, replaces the broken components. In some cases, for example, when you need only soldered suspicious areas, the replacement is not necessary, however, to be sure is still better to be safe and install a new board. What determines the success of repair? There will be a successful computer repair or not – depends on a variety of factors. First and foremost, the right to act by the owner of technology. Drawing attention to the fact that inside the device got liquid, immediately turn the power off and remove the battery. Battery does not power on board electrical discharges, even with no power and therefore can cause shock or electrolysis process. In addition to the battery source Electricity is also built into the chip card BIOS, but it is unlikely to be able you to extract yourself, so only rely on their luck. It happens so that moisture does not manage to heavily damage the computer immediately after the event, and repair laptops already required then, when a hurried user turns on the device, without waiting for complete drying of moisture. Do not repeat such mistakes! The best solution in this situation would appeal to the Service Center, where experienced craftsmen will disassemble equipment, check the correct operation of each component and prevent new damage.